Hotline:+86 31183027619      E-mail:info@highsheen.com

language
中国
韩国
韩国
韩国
韩国
韩国
Your Location:
Homepage
/
/
/
Several factors affecting the punching net

Several factors affecting the punching net

  • Categories:MESH&NETTING
  • Author:
  • Origin:
  • Time of issue:2023-02-23
  • Views:0

(Summary description)For example, if you want to reduce the thickness of the plate, you can only use a slightly more expensive alloy as the material.

Several factors affecting the punching net

(Summary description)For example, if you want to reduce the thickness of the plate, you can only use a slightly more expensive alloy as the material.

  • Categories:MESH&NETTING
  • Author:
  • Origin:
  • Time of issue:2023-02-23
  • Views:0
Information

When choosing a plate, you should consider both the application and product cost. For example, if you want to reduce the thickness of the plate, you can only use a slightly more expensive alloy as the material. The hardness and strength of the plate also directly determine the size and arrangement of the holes. Under the premise of conforming to the principle of small aperture, the appropriate thickness of the plate is more conducive to increasing the ability of the product to withstand compressive strength. Plates generally have certain tolerances.

perforated metal mesh For sale

Generally speaking, the aperture should be greater than or equal to the thickness of the plate, which is to comply with the principle of small aperture. The closer the hole diameter you require is to the thickness of the plate, the more difficult it will be to process and the higher the processing cost will be. In some materials, the aperture can be made smaller than the thickness of the sheet.
Hole spacing
The middle distance is the distance from the middle of one hole to the middle of another hole adjacent to it. The middle distance is one way to express the spacing of the holes, and the other is the opening ratio. The substantive meaning of these two representations is the same.
The porosity refers to the ratio of the area of ??the holes to the total area of ??the plate, and it can be expressed as a percentage.
Leftovers refer to the non-punched areas of the edge of the sheet. A typical orifice plate needs to be left on the long side.

Keyword:

Scan the QR code to read on your phone

Contact Us

Tel: +86 311 8302 7619
Fax: +86 311 8302 7519
E-mail:  info@highsheen.com

563919028@qq.com
Add: A-1305, ZhuoDa Commerce Building, No.88 Huai An West Road,Shijiazhuang, China

Copyright:  HIGH SHEEN INDUSTRY CO.,LTD.                                                                                                                                             冀ICP备18015706号-1       Powered by www.300.cn

HIGH SHEEN INDUSTRY COMPANY